Text preview for : DA-25_ADJ.pdf part of LG DA-25 ADJ LG Audio FFH-DV25AX FFH-DV25AX DA-25_ADJ.pdf



Back to : DA-25_ADJ.pdf | Home

SECTION 2. AUDIO PART
ADJUSTMENTS
This set has been aligned at the factory and normally will not require further adjustment. As a result, it is not
recommended that any attempt is made to modificate any circuit. If any parts are replaced or if anyone tampers
with the adjustment, realignment may be necessary.

IMPORTANT
1. Check Power-source voltage.
2. Set the function switch to band being aligned.
3. Turn volume control to minimum unless otherwise noted.
4. Connect low side of signal source and output indicator to chassis ground unless otherwise specified.
5. Keep the signal input as low as possible to avoid AGC and AC action.

TAPE DECK ADJUSTMENT
1. AZIMUTH ADJUSTMENT

Deck Mode Test Tape Test Point Adjustment Adjust for
DECK Screw
Palyback MTT-114 Speaker Out Maximum
Azimuth Screw

Electronic Dual-trace
Voltmeter synchroscope

Head
Playback Mode
Speaker Out
L out
L ch CH1 CH2

Test Tape Unit
MTT-114 R ch GND


R out



Figure 1. Azimuth Adjustment Connection Diagram

2. RECORD BIAS ADJUSTMENT

Deck Mode Test Tape Test Point Adjustment Adjust for
ERASE HEAD 60kHz