Text preview for : MP015ADJ.pdf part of LG MP015ADJ LG TV RT-44-49-54NA11T MP015ADJ.pdf
Back to : MP015ADJ.pdf | Home
ADJUSTMENT INSTRUCTIONS
Caution :
1.Because this is not a hot chassis, it is not necessary to use an 45mm
isolation transformer.
However, the use of isolation transformer will help protect
test instrument.
2.Adjustment must be done in the correct order.
3.The receiver must be operated for about 60 minutes proir to
the adjustment.
Pre-heatrun must be operated receiving moving pictures or
100% white pattern.
3. 2-Pole Magnet Adjustment
1) Make Green raster using lens cover.
2) Check the center position of DOT pattern on the center of
O Raster Slant/Focus Adjustment
the screen after turning Green focus volume left.
3) Turning green focus volume right and adjust 2-Pole magnet
1. Preliminary steps
so the position to coincide that of item 2).
1) The lens focus and electrical focus must be provisional
4) Ajust not to shift the screen by turning green focus volume
alignment.
left & right.
2) Tune the TV set to receive a EU 05 CH.
5) If the screen shifts, readjust 2)~4).
3) Press the buttons of Remote Controller for adjustment (SVC$
6) Do the same method in Red and Blue. Here, be careful not
M $5$OK$ M ) to reset the convergence.
to be stained.
2. Adjustment
1) Set only green to be appeared on the screen. 4. Beam Shape (4 & 6-Pole Magnet) Adjustment
2) Carefully rotate the DY of the green CRT so that the slant of 1) Do after 2-Pole magnet adjustment.
raster become the following figure. 2) Make Green raster using lens cover and turn the focus
volume right.
3) Make the dot in the center a perfect circle using 4 & 6-Pole
magnet.
Mechanical 4) Do the same method in Red & Blue.
center 5) Fasten the Magnet after adjustment.
L L L